Installation for Windows 95/98/2000/NT

1.  	Run Setup.exe on the disk labeled patch1.  The installer will then require disks labeled runtime1 and runtime2.
2.  	Read the readme.txt file located on the patch1 disk.
	This file details the operation of the DSA EEProm Patch.  
3. 	Install the DSA board in your machine and configure it using the Measurement & Automation Explorer.
	Make note of the device number assigned by the Measurement & Automation Explorer.  It will be
	needed for step 5.
4.  	Run Programs > DSA EEprom Patch > Patch from the Start menu.
5.  	Enter the device number of the DSA board.  This number was obtained in step 3. 
6.  	Select "Begin."
7.	After the program executes, select "Exit."
8. 	Uninstall the program by selecting Programs > DSA EEprom Patch > Uninstall DSA EEProm Patch
	from the Start menu.  You can also uninstall by selecting Settings > Control Panel > Add/Remove
	Programs from the Start menu and remove DSA EEProm Programmer.